Spektrum AR6410L User Manual page 8

EN
Installing and Plugging in the Optional Servos
Use double-sided foam tape strips and/or minimal hot glue to mount the servos
in place. The servos need to be in the appropriate position to attach to the corre-
sponding pushrods. Plug the servo leads into the appropriate servo ports in the
receiver, noting the polarity of the servo connector. Installation will vary depending
upon application.
Smart Bind™
The AR6410/AR6410L receiver must be bound to the transmitter before it will
operate. Binding is the process of programming the receiver of the control unit
to recognize the GUID (Globally Unique Identifier) code of a single specific
transmitter.The AR6410/AR6410L features Smart Bind. When the receiver is first
powered, the receiver will look for the signal of its previously bound transmitter for
5 seconds. If no signal is found, the receiver will automatically go into bind mode,
indicated by the flashing LED.
Binding
1. Make sure the flight battery is fully charged.
2. Confirm the flight battery is disconnected from the receiver/ESC unit and the
transmitter is turned off.
3. Plug the flight battery into the receiver' s battery connector. After 5 seconds the
LED on the receiver unit will flashes, indicating it is in bind mode.
4. After verifying the LED is flashing on the receiver, put the transmitter into bind
mode. (Refer to your transmitter manual for more information.)
LED
8