Spektrum AR6410L User Manual page 14

EN
Problem
LED on receiver
flashes and aircraft
will not bind to
transmitter (during
binding)
LED on receiver
flashes rapidly
and aircraft will
not respond to
transmitter (after
binding)
Control surface
does not move
Controls reversed
Possible Cause
Transmitter too near
aircraft during binding
process
Bind switch or button
not held long enough
during bind process
Less than a 5-second
wait between first
powering on transmitter
and connecting flight
battery to aircraft
Aircraft bound to
different model memory
(ModelMatch radios
TM
only)
Flight battery/
transmitter battery
charge is too low
Control surface, control
horn, linkage or
servo damage
Wire damaged or
connections loose
Flight battery charge
is low
Control linkage does
not move freely
Transmitter settings
reversed
14
Solution
Power off transmitter, move
transmitter a larger distance
from aircraft, disconnect
and reconnect flight battery
to aircraft and follow
binding instructions
Power off transmitter and
repeat bind process. Hold
transmitter bind button
or switch until receiver is
bound
Leaving transmitter on,
disconnect and reconnect
flight battery to aircraft
Select correct model
memory on transmitter and
disconnect and reconnect
flight battery to aircraft
Replace/recharge batteries
Replace or repair damaged
parts and adjust controls
Do a check of wires and
connections, connect or
replace as needed
Fully recharge flight battery
Make sure control linkage
moves freely
Do the Control Direction
Test and adjust controls on
transmitter appropriately