Multi-Meter System - Fronius Gen24 Inverter - Fronius Smart Meter TS 65A-3 Operating Instructions Manual

Multi-meter sys-
If several Fronius Smart Meter TS are installed, a separate address must be set
tem - Fronius for each (see
GEN24 inverter The primary meter is always assigned address 1. All the other meters are
numbered consecutively with the address range from 2 to 14. Different Fronius
Smart Meter power categories can be used in combination.
IMPORTANT!
Max. Use 7 secondary meters in the system. To avoid interference, it is recom-
mended to install the terminating resistors according to chapter
terminating resistor
Location of the primary meter in the consumption branch. *Terminating resistor R 120 Ohm
Location of the primary meter at the feed-in point. *Terminating resistor R 120 Ohm
26
Input Battery
Setting the address on the Fronius Smart Meter TS
on page 21.
6
0 0 1
7
Data communication
M0
*
*
Fronius Quantity
Ohmpilot Primary meter
6
0 0 1
7
1
*
Data communication
*
M1
Quantity
Secondary meter
0 4
0 2
0 1
on page 31).
Connecting the
6
0 0 1
7
2
6
0 0 1
7
2
6
0 0 1
7