Advertisement
Quick Links
Advertisement
Related Manuals for DayTronic TM3
Summary of Contents for DayTronic TM3
- Page 1 SB.3 MODEL TORQUE MONITOR INSTRUCTION MANUAL 3000 Instrument Series...
- Page 2 No part of this document may be reprinted, reproduced, or used in any form or by any electronic, mechanical, or other means, including photocopying and recording, or in any information storage and retrieval system, without permission in writing from Daytronic Corporation. All specifications are subject to change without notice.
- Page 3 Model TM3 Instruction Manual, v. SB.3 Pub. No. TM3M.3, Issued 10/96 Part No. 91416 MODEL TORQUE MONITOR INSTRUCTION MANUAL Daytronic Corporation 2211 Arbor Blvd. • Dayton, OH 45439-1521 • Tel (937) 293-2566 • Fax (937) 293-2586 www.daytronic.com...
- Page 4 BY THE INTERNAL “AUTO-RESET” CIRCUIT. c. PIN 8 is for synchronization of the TM3 when it is used as a remote unit to a Daytronic “System 10.” The signal from Pin 8 would be received by the System 10 via a Model 10AIO-16 or 10BIO- 16 Universal Logic I/O Card.
- Page 5 For Limit Mode selection and the setting of limit setpoint values, see the 3300 Manual . 4. Calibration and Operation a. Connect the transducer to the TM3 via the four- or seven-wire cable. Turn ON the TM3 via the power switch in the rear of the unit, and allow about ten minutes for warmup.
- Page 6 Daytronic Corporation 2211 Arbor Blvd. • Dayton, OH 45439-1521• (800) 668-4745 www.daytronic.com Tel (937) 293-2566 • Fax (937) 293-2586 •...