Additional Settings - ElectrIQ HS10-600-0.6DGW User Manual

ADDITIONAL SETTINGS

To Access the additional settings, press and hold the INCREASE button for 10 seconds while the
unit is in standby. While within the additional settings use the INCREASE and DECREASE buttons to
change their values, and the MODE button to move to the next setting.
OPTION MODE
TEMPERATURE
F0
COMPENSATION
OPEN WINDOW
F1
DETECTION
RADIATOR SURFACE
F2
TEMPERATURE
(COMFORT MODE)
RADIATOR SURFACE
F3
TEMPERATURE
(ECO MODE)
F4
Wi-Fi
The radiator surface temperature option can be used to limit the external temperature of the
radiator. At lower temperatures, this can help prevent the radiator from getting too hot, should it
be in close proximity to vulnerable people such as children. Even when a low surface temperature
is set, we would advise that children are supervised by a responsible person when in close
proximity to the radiator.
If the room temperature displayed is not accurate, the
temperature compensation option can be altered to improve the
accuracy of the temperature displayed. (Note due to the proximity
of the sensor to the heat source it is unavoidable for the sensor not
to be affected by the heat emitted from the heater)
Turn the open window detection feature between Off, 30 and 60.
The two figures indicate how long the unit will stay in ANTI-FROST
mode after a significant drop in room temperature is detected.
Use to set the desired maximum temperature of the radiator when
heating in comfort mode. This defaults to 80°C, but can be set
between 40°C and 80°C.
Use to set the desired maximum temperature of the radiator when
heating in eco mode. This defaults to 60°C, but can be set between
40°C and 80°C.
Use to turn the Wi-Fi on or off. Using the appliance with Wi-Fi
turned off will reduce the amount of standby power consumed by
the unit, but will prevent the use of the features within the app.
Page 11 of 31
DESCRIPTION