Configuration; To Set A Different Channel Of The Indoor Unit Infrared Signal Receiver - Daikin FTXP25M5V1B9 Installer's Reference Manual
Split system
Hide thumbs
Also See for FTXP25M5V1B9:
- Operation manual (12 pages) ,
- User reference manual (44 pages) ,
- Operation manual (16 pages)
Table of Contents
Advertisement
10
|
Configuration
10 Configuration
10.1 To set a different channel of the indoor unit infrared signal receiver
Installer reference guide
40
In case 2 indoor units are installed in 1 room, different addresses for 2 user
interfaces can be set.
1 Remove the batteries from the user interface.
2 Cut the address jumper.
a Address jumper
NOTICE
Be careful NOT to damage any of the surrounding parts when cutting the address
jumper.
3 Turn the power supply on.
Result: The flap of the indoor unit will open and close to set the reference position.
INFORMATION
▪
In case you could NOT complete the setting in time, turn the power supply off
and wait at least 1 minute before turning the power supply back on.
4 Press simultaneously:
Model
FTXP and ATXP
5 Press:
FTXP and
ATXP
6 Select:
FTXP and
ATXP
7 Press:
FTXP and
ATXP
a
a
Buttons
,
and
FTXP20~35M5V1B9
Split system air conditioners
4P519439-7S – 2021.12
Advertisement
Table of Contents
