Table of Contents
Advertisement
Applies only to Pedelecs with eShift with NuVinci
H|Sync/ enviolo with Optimized H|Sync
Screen display
Change
Gear calibration
This is where you can perform a
calibration on the stepless gear.
Press on the Lighting button to
confirm calibration. Then follow the
instructions. You also might need
to perform a calibration while riding
in the event of a fault. In such
cases, you also press on the
Lighting button to confirm
calibration and then follow the
instructions on the display. This
menu option is only shown when
the on-board computer is
positioned in its mount
Gear vx.x.x.x:
this is the gear software version.
This menu option is only shown
when the on-board computer is
positioned in its mount. This menu
option is only shown if you have an
electronic control gear.
Table 47: Changing the system settings
Applies only to Pedelecs with eShift with Rohloff
E-14 Speedhub 500/14
Screen display
Change
Start gear
This is where you can set the start
gear.
The automatic reset function is
switched off in Position – –. This
menu option is only shown when
the on-board computer is
positioned in its mount.
Gear vx.x.x.x:
this is the gear software version.
This menu option is only shown
when the on-board computer is
positioned in its mount. This menu
option is only shown if you have an
electronic control gear.
Table 48: Changing the system settings
3.6.5
System message
The drive system monitors itself continuously and
if an error is detected, it is indicated by a system
message. The system may switch off
automatically depending on the type of error. You
will find assistance for system messages in 8.5
First aid. There is a table of system messages in
the Appendix.
MY20H02-12_1.0_12.06.2019
3.6.6
ABS indicator lamp
The anti-blocking system indicator lamp must light
up after the system has started up and must go
out once speed has reached about 5 km/h. If the
ABS indicator lamp does not light up when the
electric drive system starts, the ABS is defective.
An error code on the display also tells the rider
that it is defective.
If the indicator lamp does not go out after you set
off or it lights up while you are riding, this means
there is an error in the anti-blocking system. The
anti-blocking system is then no longer active. The
brake system itself remains functional. It is only
the anti-blocking system control which no longer
operates.
If the ABS indicator lamp is lit, the ABS function is
not active.
Notice
The anti-blocking system indicator lamp may light
up if the front and rear wheels are rotating at
widely different speeds from one another – for
example, if the rider cycles on the rear wheel only
or if a wheel is rotating for a unusually long time
without making contact with the ground (fitting
stand). The anti-blocking system switches off in
such cases.
Note: You need to stop and restart the pedelec
(switch off and on again) to reactivate the anti-
blocking system.
Overview
40
Advertisement
Table of Contents
