Epson ES-C320W User Manual page 180

Administrator Information
Item
Enable WSD
Scanning Timeout (sec)
Device Name
Location
LLTD Settings
Item
Enable LLTD
Device Name
LLMNR Settings
Item
Enable LLMNR
SNMPv1/v2c Settings
Item
Enable SNMPv1/v2c
Access Authority
Community Name (Read Only)
Community Name (Read/Write)
Allow access from Epson tools
SNMPv3 Settings
Item
Enable SNMPv3
User Name
Authentication Settings
>
Advanced Security Settings
Settings and Explanation
Select this to enable adding devices using WSD and scan
from the WSD port.
Enter the communication timeout value for WSD scanning
between 3 to 3,600 seconds.
Displays the WSD device name.
Displays the WSD location name.
Settings and Explanation
Select this to enable LLTD. The scanner is displayed in the
Windows network map.
Displays the LLTD device name.
Settings and Explanation
Select this to enable LLMNR. When this is enabled, you can
use name resolution without NetBIOS even if you cannot use
DNS.
Settings and Explanation
Select to enable SNMPv1/v2c.
Set the access authority when SNMPv1/v2c is enabled. Se-
lect Read Only or Read/Write.
Enter within 32 characters in ASCII (0x20-0x7E). If you do not
specify this, leave it blank.
Enter within 32 characters in ASCII (0x20-0x7E). If you do not
specify this, leave it blank.
Set whether to allow writing from Epson tools such as Epson
Device Admin.
Settings and Explanation
SNMPv3 is enabled when the box is checked.
Enter between 1 and 32 characters using 1 byte characters.
180
>
Controlling Using Protocols