WMF PERFECTION 600 Series Operating Instructions Manual page 27

FUNCTION
Using
beverages
Using
milk froth
PROBLEM
There is water underneath the
appliance.
There is water in coffee
ground retainer.
When you turn off the
appliance, warm water flows
out of the coffee outlets and
the One Touch Cappuccino
block.
The One Touch Cappuccino
block does not suck the milk.
The One Touch Cappuccino
blocks produces little or no
froth.
The milk or water is not
flowing correctly into the
cup(s).
There are traces of milk in an
Americano or a Hot water.
The espresso or coffee is not
hot enough.
CORRECTIVE ACTION
Before removing the water tank, wait for 15
seconds after the coffee has finished flowing so
that the appliance finishes its cycle properly. Check
that the drip tray is correctly positioned on the
machine; it should always be in place, even when
the appliance is not in use. The drip tray should not
be removed during a cycle.
If some water is flowing on the upper cover of the
appliance, this flowing is directly conducted to
coffee retainer. Avoid to stack a fully cup on the
top of the appliance.
According to the type of recipe prepared, the
machine may run an automatic rinsing cycle when
it is turned off, to avoid clogging. This cycle lasts
only a few seconds and stops automatically.
Check that the block is assembled correctly (in
particular the connector in the milk tube). Ensure
that the steam nozzle is not blocked. If this is the
case, see below "The steam nozzle on your machine
seems to be partially or completely blocked". Check
that the connector is not blocked or dirty; soak it
in a mixture of hot water and washing-up liquid,
then rinse and dry before reassembling. Ensure
that the flexible pipe is not blocked or twisted
and that it is properly inserted into the One Touch
Cappuccino block in order to avoid any air leaks.
Check that it is fully immersed in the milk. Rinse
and clean the block (see chapters concerning
rinsing and cleaning the One Touch Cappuccino
block).
For milk drinks, we recommend that you use fresh,
pasteurized or UHT milk which has been recently
opened. It is also advisable to use a cold container.
Check that the One Touch Cappuccino block
correctly positioned.
Complete a milk rinsing cycle or dismantle and
clean the One Touch Cappuccino accessory before
running the preparation.
Run a coffee circuit rinsing cycle before preparing
your coffee. Increase the coffee temperature in the
advanced menu or in the settings menu. Warm the
cup by rinsing it with hot water before making the
drink. Choose a cup according the volume of recipe
you request. Or heat the cup by rinsing it, using
the one touch hot water function.
27
is
2