Table of Contents
Advertisement
Programming Examples
Trapezoidal Wave Output
Sets trigger delay time
Enables/disables channel
Initiates specified action
Reads result data (array data)
v-or-c is VOLT for voltage source or limit (compliance), or CURR for current source
or limit (compliance).
func is VOLT for voltage measurement, CURR for current measurement, or RES for
resistance measurement.
func2 is VOLT for voltage measurement or CURR for current measurement.
source is AINT for the automatic trigger, BUS for the remote interface trigger
command, TIM for the internal timer, INTn for a signal from the internal bus (n = 1
or 2), EXTm for a signal from the GPIO pin m (m = 1 to 14), or LAN for the LXI
trigger.
type is VOLT for voltage data, CURR for current data, RES for resistance data,
SOUR for source output data, STAT for status data, or TIME for time data.
chanlist is (@1) for selecting the channel 1 only, (@2) for selecting the channel 2
only, or (@1,2), (@1:2), (@2,1), or (@2:1) for selecting both channels 1 and 2.
Abbreviating this parameter sets chanlist = (@1) for the 1-channel models, and
chanlist = (@1,2) for the 2-channel models.
70
Function
Keysight B2961B/B2962B Programming Guide, Edition 1
Command
:TRIG[c]<:ACQ | :TRAN | [:ALL]>:DEL time
:OUTP[c] <ON | OFF>
:INIT<:ACQ | :TRAN | [:ALL]> [chanlist]
:FETC:ARR:type? [chanlist]
Advertisement
Table of Contents
