Table of Contents
Advertisement
Inspect all electrical connections, making sure they are properly attached to their specified connection points before
1.A) Install venture power harness
(VE1020737) into the designated
location on the UCB and venture.
Board must point up
1.D) Utilize the three cable clips indicated
above in order to ensure the motion
sensor board (VE6822) stays upwards
and doesnt short.
2.A) Connect UCB temperature
sensor extension (VE1016368)
to temperature cable with probe
(VE1015669).
9
ATTACH HARNESSES
CAUTION
!
powering up machine.
Step 1: Install Venture Harnessing
1.B) Install venture RS-232 data harness
(VE1019772) into the designated
location on UCB and venture.
1.E) Install venture speaker
(VE1019798) into the designated
port on the back of the venture as
shown.
Step 2: Install Other Harnessing
2.B) Nest the temperature probe
(VE1015669) around the EVAP coil
inside the cabinet .
VE1021164 - BEVMAX - MEDIA PANEL INSTALLATION MANUAL
www.veii.com
Board must point up
1.C) Install motion sensor harness
(VE6822) into the designated location
on the venture and motion censor.
1.F) If using a cellular modem , connect
the modem to the venture board in
the first USB port as shown. If not,
ignore this step.
2.C) Feed the temperature probe
(VE1015669) and extension
(VE1016368) into the side cabinet.
Connect extension to the control
board as shown.
Advertisement
Table of Contents
