Cleaning And Maintenance Schedule - Centrometal EKO-CUP SV3 2500 Technical Instructions

Cleaning and maintenace
14.0. CLEANING AND MAINTENANCE
- Before opening the boiler door the boiler must be switched off and cooled.
- Before any work on the boiler, power supply must be switched off.
! !
- Protective gloves are obligatory.
- Before any work on the boiler shut off main gas /oil supply!
Figure 6: Protective gloves
Protective gloves are obligatory!

CLEANING AND MAINTENANCE SCHEDULE

ITEM
Clean the boiler.
Burner check by an
authorized service
technician.
Heating system check.
18
INTERVAL
Min. once per year
( b e f o r e h e a t i n g
season)
Min. once a year
( b e f o r e h e a t i n g
season)
Before boiler use
DESCRIPTION
Before cleaning the boiler switch off the main
switch on the boiler control panel. This action
prevent a possible burner start. Open the boiler
door, pull out turbulators and clean boiler tubes
and the combustion chamber with the brush. The
flue gas chamber and turbulator tube endings can
be cleaned through the opening at the back of the
boiler. After cleaning return turbulators and the lid
of the cleaning opening and close the boiler door.
An authorized service technician has to check the
burner (and set new burner settings if necessary).
Check if the whole installation is in accordance
with provided general information by the
contractor regarding to the heating system
operation, position and function of important
components in the system. Air-vent the heating
system and fill it with water if is necessary.
Technical instructions EKO-CUP SV3 2500