Troubles About The Album On The Web; Troubles About Sending A Still Image (Dcr-Trv80 Only) - Sony Handycam DCR-TRV70 Operating Instructions Manual
Sony handycam dcr-trv70: operating instruction
Hide thumbs
Also See for Handycam DCR-TRV70:
- Brochure (2 pages) ,
- Operating instructions manual (220 pages) ,
- Service manual (101 pages)
Table of Contents
Advertisement
Troubleshooting
Troubles about the Album on the Web
The message "DI Customer ID profile Incomplete" appears and your camcorder cannot access
the Album on the Web.
c
The DI customer ID is required to use the Album on the Web.
You cannot view or edit your album, send an invitation card, or upload still images and/or
moving pictures. (A four-digit error code appears.)
c
See "Album error codes" (p. 145).
It takes some time to load the album.
c
The web page may be busy. Try connecting through another provider or access point,
or connect during off-peak times.
A still image or moving picture cannot be deleted.
c
There may be no still images and/or moving pictures. Tap
A still image or moving picture cannot be downloaded.
c
There may be no still images and/or moving pictures. Tap
Troubles about sending a still image
– DCR-TRV80 only
SEND does not function.
c
A still image is not being played back.
c
An invalid image is being played back.
The message "Bluetooth Authentication Error" appears, and you cannot send a still image.
c
The authentication time limit (30 seconds) is over.
c
You did not enter the correct passkey.
c
The connected device was disconnected.
c
The passkey you entered is wrong. Enter the correct passkey.
The message "Bluetooth Connection Error" appears, and you cannot send a still image.
c
The Bluetooth device you want to connect to is not turned on.
c
The Bluetooth device is too far from your camcorder.
c
The radio waves between your camcorder and the connected device were blocked.
c
The Bluetooth device you want to connect to is already connected to other devices.
c
The connected device was disconnected.
c
The Bluetooth device you want to connect to is not compatible with BIP.
The message "Bluetooth Communication Disconnected" or "Send Error" appears, and you
cannot send a still image.
c
The connected Bluetooth device is turned off.
c
The Bluetooth device is too far from your camcorder.
c
The radio waves between your camcorder and the connected device were blocked.
c
The connected device was disconnected.
c
The Bluetooth device you want to connect to is not compatible with BIP.
c
The connection was rejected by the connected Bluetooth device. Check the settings or
operations of the connected device.
c
You sent the still image that the connected Bluetooth device cannot receive.
134
.
.
Hide quick links:
Advertisement
Table of Contents
