Troubles About Receiving A Still Image (Dcr-Trv80 Only) - Sony Handycam DCR-TRV70 Operating Instructions Manual

Troubleshooting
Troubles about receiving a still image
– DCR-TRV80 only
The message "Bluetooth Authentication Error" appears, and you cannot receive a still
image.
c The authentication time limit (30 seconds) is over.
c You did not enter the correct passkey.
c The connected device disconnects or ends the connection.
c The passkey you entered is wrong. Enter the correct passkey.
The message "Bluetooth Communication Disconnected" or "Error Receiving" appears, and
you cannot send a still image.
c The connected Bluetooth device is turned off.
c The Bluetooth device is too far from your camcorder.
c The radio waves between your camcorder and the connected device were blocked.
c The connected device disconnects or ends the connection.
c The "Memory Stick" does not have enough capacity.
c The sent still image is not a JPG or JPEG file.
c The sent still image is too large.
The message "Bluetooth connection Timeout" appears.
c If your camcorder does not receive any requests from the connected device for five
minutes, the connection is disconnected or the camera becomes non-connectable.
Connect your camcorder and the Bluetooth device again.
No request from the connected device.
c The device you want to connect with your camcorder is connected to other device.
Disconnect the connection and connect the device with your camcorder.
c The time limit was exceeded. Set your camcorder to connection standby again.
The received still image cannot be played back.
c Your camcorder may not be able to play back incompatible JPEG files or files recorded
by other devices properly.
c The still image is corrupted.
The index screen becomes blue.
c The received files do not have thumbnails.
135