Table of Contents
Advertisement
Troubleshooting
Troubles about the album on the Web
The message "DI Customer ID profile Incomplete" is indicated and your camcorder cannot
access the album on the Web.
c
The DI customer ID is required to use the album on the Web.
You cannot view or edit your album, send an invitation card, or upload images. (An error
code is indicated.)
c
See "Album error codes" (p. 105).
It takes some time to load the album.
c
When the web site is busy, try to connect through other providers or access points, or
connect during off-peak times.
The image cannot be deleted.
c
There may be no images. Tap
The image cannot be downloaded.
c
There may be no images. Tap
Adjusting the LCD screen (CALIBRATION)
The buttons on the touch panel may not work correctly. If this happens, follow the
procedure below.
(1) Set the POWER switch to OFF (CHG).
(2) Eject the cassette from your camcorder, then disconnect any connecting cable
(3) Set the POWER switch to VCR while pressing DISPLAY/TOUCH PANEL on
(4) Follow the procedure below using the stylus supplied with your camcorder.
Note
If you do not tap the right spot,
corner. In this case, start from step 4 again.
100
from your camcorder.
your camcorder, then keep pressing DISPLAY/TOUCH PANEL for about five
seconds.
1 Touch
at the upper left corner.
2 Touch
at the lower right corner.
3 Touch
in the middle of the screen.
CALIBRATE
(Refresh).
(Refresh).
CALIBRATE
always returns to the position at the upper left
CALIBRATE
Advertisement
Table of Contents
