Maxwell MW-2108 B Instructions Manual page 9

ENGLISH
Hair clipper
Description
1. Power switch «ON/OFF»
2. Taper lever
3. Lower blade
4. Upper blade
5. Hanging loop
6. 3 mm attachment comb
7. 6 mm attachment comb
8. 9 mm attachment comb
9. 12 mm attachment comb
10. B lade protective cover
11. C omb
12. S cissors
13. L ubricating oil
14. C leaning brush
Safety measures
Before using the unit, read this instruction care-
fully. Keep this instruction for future reference.
Use the unit for intended purposes only, as
specified in this manual. Mishandling the unit
can lead to its breakage and cause harm to the
user or damage to his/her property.
• Before using the unit for the first time, make
sure that voltage in your mains corresponds
to unit operating voltage.
• Use only the attachment combs supplied.
• Never use the unit if the comb attachments
are broken or damaged or if the blades are
damaged.
• Keep the blades clean and lubricated.
• After each usage clean the blades using the
brush supplied with the unit.
• Do not leave the operating unit unattended.
• Switch the unit off during intervals in opera-
tion or when you do not use it.
• Do not use the unit in places with high tem-
perature and humidity and while taking a bath
or a shower.
• Do not keep the unit near a bath or a sink,
filled with water. Do not immerse the unit into
water or other liquids; do not wash the unit
under running water.
• Make sure that the cord does not touch hot
surfaces or sharp objects.
• Before using the unit make sure that the
blades are set properly. If you find blades
tilted, level them (refer to Blades leveling
section).
• Do not allow children to use the unit as a toy.
Keep the unit away from children.
• This unit is not intended for usage by children
or disabled persons unless they are given all
the necessary instructions by a person who
is responsible for their safety on safety mea-
sures and information about danger that can
be caused by improper usage of the unit.
• For children safety do not leave polyethylene
bags, used as a packaging, unattended.
• Attention! Do not allow children to play with
polyethylene bags or film. Danger of suf-
focation!
• Do not use the unit if the power cord or the
plug is damaged.
• Do not repair the unit by yourself; always
apply to the authorized service center.
THE UNIT IS INTENDED FOR HOUSEHOLD US-
AGE ONLY
Using of hair clipper
– In case of unit transportation or storage at
low temperature it is necessary to keep it
for at least two hours at room temperature
before switching on.
– Remove all stickers and packaging elements
that can prevent unit operation.
Blades leveling
If the blades were removed for cleaning or re-
placement, they need to be leveled.
– Level the blades and tighten the fastening
screws. The lower blade (3) should be 1-2
mm protruded relative to the upper blade (4).
– If you could not level the blades, add some
oil (13) drops on the blades, switch the unit
on for a while (30-40 sec.), then switch it off
and take the plug out of the socket. Slightly
loosen the fastening screws of the lower
blade (3) and level the blades. Do not for-
get to tighten the lower blade (3) fastening
screws after leveling.
Lubricating oil
– To maintain the unit in a good condition, you
should periodically lubricate the blades. Do
not use vegetable oil or oil that includes sol-
vents. Solvents are subjected to evaporation,
8