Instruction For Use; Cleaning And Maintenance - Bartscher VT-07 E Instructions For Installation And Use Manual

• safety fuse of the feeder and inner mains can stand the loading of the device (see label of the matrix)
• mains are equipped with effective grounding according to standards (ČSN) and conditions given by law
• socket or switch of the feed is well accessible from device
We refuse any responsibility in case of not respecting above mentioned rules. Before the first use it is necessary
to remove all the protection foil and to clean the device - see chapter „cleaning and maintenance".
Maintenance: We recommend to have the device checked once a year by the proffesional service. Only qualified
or competent persons can do interventions in the product.

INSTRUCTION FOR USE

Attention!Before the first use of the device you must remove protection foil from all surfaces and wash the device
with water with detergent. Than splash it with clean water. Use the device under supervision. Never use the
device without water or if the level of the oil is lower then min. line - danger of fire.Fill the device with water not
higher than the line on the side. Switch on the device by puting the cable to the elektricity and turn the circle
knob to required position between 90°C - 110°C. Pilot lamp lights when the thermo spirals are on. Pilot lamp
goes out when the device reaches required temperature. Switch the device off by turning the knob into position
„0" and pull the cable from the plug.
Comments and recommendation
You must always check the level of water, never use the device without water.Use the device only under
supervision.

CLEANING AND MAINTENANCE

ATTENTION! The device cannot be cleaned by direct or pressure water.Clean it daily. Daily maintenance keeps
longer useful life and efficiency of the device. Before cleaning make sure to have disconnected the device from
electricity. Always switch off the main feeder to the device. Stain-less parts wash with moist cleaning cloth and
detergent without groove parts than dry it by the cloth - mainly around the regulation knob, main switch, cable
bushing, feeding cable, microswitch and fit-on listel. Do not use abrasive and corrosive detergents.
How to clean heating elements - take out the box with heating elements. Clean the heating elements only with
moist cloth.How to discharge the oil - take out the bown with the aid of handles on the sides. Do this only when
the oil is cold. You can wash the bowl in the dishwasher. After washing it dry it with cloth and fill it with filtrated
or new oil.
WHAT TO DO IN CASE OF BREAK-DOWN
Switch off the electric feeder and call seller´s proffesional service.
INDICATION
Guarentee does not cover all consumption parts succumable to common wear (rubber seals, bulbs, glas and
plastic parts etc.). The guarantee does not refer to the devices which were not instaled in correspondance with
instructions - by qualified worker, in confirmity with standards and when somebody handled incompetently the
device (interventions into inner equipment) or the device was operated by nonqualified staff or at variance with
instructions for use. Guarantee does not also cover the damages caused due to influance of nature or other
outer intervention.
5