Replacing A Turn Signal Light Bulb; Replacing A License Plate Light Bulb - Yamaha Star 2011 Owner's Manual

U1BH12E0.book Page 35 Wednesday, July 6, 2011 4:06 PM
PERIODIC MAINTENANCE AND ADJUSTMENT
Replacing a turn signal light
bulb
1. Remove the turn signal lens by re-
moving the screws.
1. Screw
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
7
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws. NOTICE: Do not over-
tighten the screws, otherwise
the lens may break.
[ECA10681]
EAU24212
Replacing a license plate light
bulb
1. Remove the license plate light unit
by removing the bolts.
1
1. Bolt
2. Remove the license plate light bulb
socket (together with the bulb) by
turning it counterclockwise, and
then pulling it out.
7-35
EAU31964
1. License plate light bulb socket
3. Remove the burnt-out bulb by pull-
ing it out.
1. License plate light bulb
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by pushing it in, and then turn
it clockwise until it stops.
1 1