Cleaning The Air Filter Element - Yamaha Star 2011 Owner's Manual

Table of Contents

U1BH12E0.book Page 16 Wednesday, July 6, 2011 4:06 PM

To change the transfer case oil

1. Place an oil pan under the transfer

case to collect the used oil.

2. Remove the transfer case oil drain

bolt, the oil level check bolt and

their gasket to drain the oil from the

transfer case.

1. Transfer case oil drain bolt

2. Gasket

3. Install the drain bolt and its new

gasket, and then tighten the bolt to

the specified torque.

Tightening torque:

Transfer case oil drain bolt:

18 Nm (1.8 m·kgf, 13 ft·lbf)

4. Check the oil level check bolt gas-

ket for damage, and replace it if

necessary.

PERIODIC MAINTENANCE AND ADJUSTMENT

5. Install the oil level check bolt and

its gasket, and then tighten the bolt

to the specified torque.

Tightening torque:

Transfer case oil level check bolt:

8 Nm (0.8 m·kgf, 5.8 ft·lbf)

6. Remove the oil filler cap, refill with

the specified amount of the recom-

mended transfer case oil, and then

install and tighten the oil filler cap.

NOTICE: Make sure that no for-

eign material enters the transfer

case.

[ECA10871]

Recommended transfer case oil:

See page 9-1.

Oil quantity:

0.40 L (0.42 US qt, 0.35 Imp.qt)

7. Start the engine and let it idle for

several minutes while checking the

transfer case for oil leakage. If oil is

leaking, immediately turn the en-

gine off and check for the cause.

7-16