Dubbing Only Desired Scenes - Digital Program Editing - Sony DSR-250 Operating Instructions Manual

Dubbing only desired scenes – Digital
program editing
You can duplicate selected scenes (programs) for editing onto a tape without operating
the VCR. Scenes can be selected by frame.
To use this function, a DV connecting cable (i.LINK cable) (not supplied) will be
required.
[a]
[a] Undesired frame
[b]Moves the scene
To do the digital program editing
Make sure that the external VCR to be connected is equipped with the DV IN connector.
This camcorder is used as player.
Before operating the digital program editing
Preparation 1 Connecting the VCR. (below)
Preparation 2 Adjusting the synchronization of the VCR (p. 89).
When you dub using the same VCR again, you can skip Preparation 2.
Using the digital program editing function
Operation 1 Making programs. (p. 91)
Operation 2 Performing a digital program editing (Dubbing a tape). (p. 93)
Notes
•You cannot dub the titles, display indicators, or the contents of cassette memory.
•If you start recording from the very beginning of the tape, the first few seconds of the
tape may not record properly. Be sure to allow about 10 seconds' lead before starting
the recording.
Preparation 1: Connecting the VCR
Connect your camcorder and the VCR as shown on page 86.
88
[a]
[b]