Table of Contents
Advertisement
Supervisor level
Remote Update
The RemoteUpdate function is used for
updating the software in your tumble
dryer.
Factory default: On
If you do not install a RemoteUpdate,
you can continue to use your tumble
dryer in the usual way. However, Miele
recommends installing RemoteUpdates.
Activation
The RemoteUpdate menu option is
only displayed and can only be
selected if you have added your
tumble dryer to your WiFi network.
Miele's RemoteUpdate function can
only be used if the tumble dryer is
connected to a WiFi network and you
have an account in the Miele
Professional app. The tumble dryer
must be registered in the app.
See the Miele Professional app for
terms and conditions of use.
Some software updates can only be
carried out by Miele Technical Service.
106
Running a RemoteUpdate
If a RemoteUpdate is available for your
tumble dryer, it will be displayed
automatically when the supervisor level
is open.
You can choose to start the
RemoteUpdate immediately or wait until
later. If you select "Start later", the
prompt to run the RemoteUpdate will
be displayed again the next time you
switch on your tumble dryer.
The RemoteUpdate can take a few
minutes.
Please note the following information
about the RemoteUpdate function:
- You will only receive a message when
a RemoteUpdate is available.
- Once a RemoteUpdate has been
installed, it cannot be undone.
- Do not switch off the tumble dryer
during a RemoteUpdate. Otherwise,
the RemoteUpdate will be aborted
and will not be installed.
SmartGrid
The
setting is only visible if a
SmartGrid
WiFi network has been set up and
activated. You can use this function to
integrate your tumble dryer into
building energy management systems.
Factory default: Off
Advertisement
Table of Contents
