Table of Contents
Advertisement
Supervisor level
WiFi / LAN
For the use of WiFi / LAN additional
Miele digital products are necessary.
The ability of Miele digital products
depends on the availability of the
services in your country.
The different services are not available
in all countries.
For information about availability,
please visit www.miele.com.
Control the networking of your tumble
dryer.
- Setup
This message only appears if the
tumble dryer has not yet been
connected to a WiFi network.
- Deactivate (visible when the network
is activated)
The network remains set up; the WiFi
function is switched off.
- Activate (visible when the network is
deactivated)
The WiFi function is reactivated.
- Connection status (visible when the
network is activated)
The following values are displayed:
– The quality of WiFi reception
– The network name
– The IP address
- Reset (visible when set up)
Resets the WiFi login (network) to
immediately re-establish a new
connection.
- Reset (visible if already set up)
104
The network is no longer set up. A
new connection has to be
established in order to use the
network again.
– The WiFi is switched off
– The WiFi connection will be reset
to the factory default setting
WiFi setup
There are 2 possible connection
methods.
Via WPS
Activate the WPS function on your
router within 2 minutes.
Tip: If the connection has not been set
up when the timeout has finished
counting down, repeat the process.
via Soft AP
Activate the function with the Miele
app on your smart device within
10 minutes.
Advertisement
Table of Contents
