Maintenance; Spare Parts - R&S ENY21 Operating Manual

R&S ENY-FTS

4 Maintenance

The R&S ENY-FTS does not require special maintenance. Users need only take care
to keep the equipment clean and protect the components against mechanical damage.
The connectors have only a limited number of insertion/withdrawal cycles. If the
connectors show signs of wear, you should have Rohde & Schwarz Service replace
the connectors. Users are not permitted to modify the device.
Clean the instrument housing using a dry cloth. For heavy dirt, use a damp cloth with a
mild, non-abrasive household cleanser if necessary. Do not let liquid enter the housing
of the device. No chemicals may be used for cleaning purposes.

4.1 Spare parts

For the Adapter Set R&S ENY-FTS the following spare parts are available::
Sachnummer
1309.8710.03
1309.8890.00
1309.8478.00
1309.8484.00
1309.8678.00
1309.8684.00
1309.8855.00
1309.8690.00
1309.8849.00
1309.8278.00
1309.8661.00
1309.8449.00
1309.8455.00
1309.8461.00
1309.8990.00
1309.8884.00
(2x) 1309.8932.00
1309.8810.00
1309.8378.00
1309.8803.00
1309.8284.00
Operating Manual 1309.8949.14 - 02
Designation Comment
BMB-1000 LCL Balance Measurement Bridge, 100 kHz to 100 MHz
A-REFLOAD Reference Load for LCL Measurement Bridge (LCL ca. 55 dB)
A-CALLOAD Calibration Load for Balance Measurement Bridge (0 dB)
A-TERMINATION Termination for Balance Measurement Bridge (100 C)
A-OPEN Termination for ISN (D-Sub 25, Open)
A-SHORT Termination for ISN (D-Sub 25, Short)
A-50 Termination for ISN (BNC, 50 C)
A-150 Termination for ISN (D-Sub 25, 150 C)
A-800 Termination for ISN (D-Sub 25, 100 C for each pair of wires)
A-801 Termination for ISN (RJ45, 100 C for each pair of wires)
SAR M116 Adapter, 4-mm-Banana
SAR T2x0 Common Mode Adapter for 2-Wire-ISN, 1mm Banana
SAR T4x0 Common Mode Adapter for 4-Wire-ISN, 1mm Banana
SAR T8x0 Common Mode Adapter for 8-Wire-ISN, 1mm Banana
SAR T602 Common Mode Adapter for RJ11
SAR T801 Common Mode Adapter for D-Sub 25
2x SAR T802 Common Mode Adapter for RJ45
Jig IMA U0 Impedance Measurement Adapter (0 C)
Jig CAL U100B
Calibration Adapter (100 C)
Jig LCL-Probe Measurement Adapter for LCL Balance Measurement Bridge
Jig TRA U0-150 Termination Adapter for Calibration (150 C and Short)
Maintenance
18