Table of Contents
Advertisement
After Boating and Maintenance
• Fully dry the inside and outside of the boat.
• Remove the hatch before storing your boat.
• Repair any damage or wear to the boat.
• Lubricate the driveshaft using ProBoat
Marine Grease (DYNE4200).
• Make note of lessons learned from the trimming of
your boat, including water and wind conditions.
Binding
Binding is the process of programming the receiver/ESC
to recognize the GUID (Globally Unique Identifier) code of
a single specific transmitter. The transmitter and receiver/
ESC are bound at the factory.
If you need to rebind the binding is process is automated,
there is no bind plug or button on the receiver.
1. Hold Aux 3 on TX and power on, the LED on the
transmitter will flash, indicating it is in bind mode.
2. Power on the ESC/RX, the LED will flash until bound.
3. Restart the transmitter to complete the binding
process.
You must rebind when:
• When you want different failsafe positions (e.g.
when throttle or steering reverse has been
changed).
• Binding the receiver to a different transmitter.
Motor Care
• Prolong motor life by preventing overheating
conditions.
• Regularly lubricate (DYNE0100) the bushings on each
end of the motor and more frequently when the
motor is wet. Failure to do so may cause the motor
shaft to seize in the bushings.
12 - INCH READY - TO - RUN POOL RACER
NOTICE: When you are finished boating, never leave the
boat in direct sunlight or in a hot, enclosed area such as a
car. Doing so can damage the boat.
NOTICE: Do not attempt to bind the transmitter and
receiver/ESC if there are other compatible transmitters
in bind mode within 400 feet. Doing so may result in
unexpected binding.
Failsafe
In the unlikely event that the radio connection is lost
during use, the receiver will drive the servos to their
pre-programmed failsafe positions (normally no throttle
and straight steering).
If the receiver is powered on before powering on the
transmitter, the receiver enters Failsafe mode. When the
transmitter is powered on, normal control is resumed.
IMPORTANT: Failsafe activates only in the event
that signal is lost from the transmitter. Failsafe will
NOT activate in the event that receiver battery power
decreases below the recommended minimums or power
to the receiver is lost.
• Use water displacement fluid to flush any water from
the motor compartment.
EN
9
Advertisement
Table of Contents
