Switching On; Selecting And Starting The Program - Smeg STO905U Instruction Manual

USER INSTRUCTIONS
Only run the soak program with half loads.
The multi-zone option (ref. 9 fi g. 2-02) is available for all programs, except
soak.
To run programs 6, 7, 8, 9, 10 (see tab. 2-02b), select the required standard
program (see programs 1, 2, 3, 4, 5 in tab. 2-02a) and then press the supple-
mentary program button (ref. 6 fi g. 2-02).
After using the above tables to choose the most suitable washing cycle, pro-
gram the appliance.
Before starting a washing program, make sure that:
• The water supply tap is open.
• There is regenerating salt in the water softener tank (to add
salt, see the instructions in the general manual).
• The correct amount of detergent has been added to the dis-
penser (to add detergent, see the instructions in the general
manual).
• The spray arms are able to rotate freely and without obstruction.
• The racks have been correctly loaded (see the instructions in the
general manual).
• The dishwasher door is securely closed.
2.2.1

Switching on

Press the on/off button (ref. 1 fi g. 2-02) to start the dishwasher. Then wait for
one of the program indicator lights to turn on (ref. 2 fi g. 2-02).
2.2.2

Selecting and starting the program

• Press the program selection button (ref. 3 fi g. 2-02) several times until
the indicator light corresponding to the required program turns on (ref. 2 fi g.
2-02);
• if required, press the relative buttons to select any complementary functions
(e.g.: "half-load", "program delay"; see para 2.2.7 "options");
• close the door; the program will start after about 2 seconds and the relative
indicator light will fl ash throughout the cycle (program¬ running signal).
If the door of the dishwasher has not been closed or has been incor-
rectly closed, the washing cycle will not begin.
Rev 0.0
EN
9