Changing The Dust Bag; Maintenance - Linea 2000 DOMO DO-7255S Instruction Booklet

DO-7255S
INSTRUCTIONS FOR USE
1. Button to rewind the cable :
Pull the cord out of the appliance as far as necessary. Make sure you don't exceed the red marking on
the wire. Keep hold of the plug during the rewinding of the cord. You can press the button with your
foot to rewind the cable.
2. Suction power regulation :
Use the sliding knob to adjust the suction power of your vacuum cleaner.
3. When the red marking that indicates the change of the dust bag becomes visible, you should check
the following :
- Is the dust bag full ? If so change it.
- Is the dust bag blocked ? If so remove the blockage immediately.

CHANGING THE DUST BAG

The vacuum cleaner cannot be used without the dust bag. When the dust bag is full or damaged you
need to replace it immediately.
1. Pull the knob of the lid of the dust bag to open it.
2. Remove the dust bag and place a new one in the correct position.

MAINTENANCE

1. Motor filter
The motor filter is situated in the dust bag compartment. You need to change or clean the motor filter
when it is visible dirty. This can improve the efficiency of your vacuum cleaner and prolong the life.
It is recommended to at least clean the motor filter twice a year.
1. Remove the filter
2. Clean it thoroughly
3. Let it dry by exposure to air
4. Replace it into the vacuum cleaner
2. Micro filter
When the micro filter, which is situated at the back, becomes dirty you need to clean it or replace it.
When the filter becomes dirty the airflow will be obstructed, with the possibility of over heating your
vacuum cleaner. This can lead to a malfunction of your vacuum cleaner.
1. remove the lid of the micro filter.
2. Clean the filter thoroughly by beating it out or replace it. Don't wash !
3. Replace the filter.
4. Place the lid back on the vacuum cleaner.
11