Description Of The Parts; Changing The Dust Bag - Linea 2000 DOMO DO7236S Instruction Booklet

DESCRIPTION OF THE PARTS

1. On/off switch
2. Cord rewinder
3. Suction power regulation
4. Dust bag lid
5. Indication for bag change
6. Clip opening dust bag compartment
7. Floor brush
8. Flexible hose
ASSEMBLY
1. Attach the hose to the hose connection of the vacuum cleaner.
2. Attach the metal tube to the hose.
3. Connect the floor brush to the metal tube.
INSTRUCTIONS FOR USE
1. Button to rewind the cable:
Pull the cord out of the appliance as far as necessary. Make sure you don't
exceed the red marking on the wire. Keep hold of the plug during the rewinding
of the cord. You can press the button with your foot to rewind the cable.
2. Suction power regulation:
Use the slider button to adjust the suction power of your vacuum cleaner.
3. When the red marking that indicates the change of the dust bag becomes visible,
you should check the following:
• Is the dust bag full? If so change it.
• Is the dust bag blocked? If so remove the blockage immediately.
• Is the floor brush, tube or hose blocked? If so remove the blockage
immediately.

CHANGING THE DUST BAG

The vacuum cleaner cannot be used without the dust bag. When the dust bag is full or
damaged you need to replace it immediately.
1. Pull the clip of the lid of the dust bag to open it.
2. Remove the dust bag and place a new one in the correct position.
1
3
2
4
27
DO7236S
8
5
6
7