Changing And Cleaning The Dust Cup Filter - Linea 2000 DOMO DO-203S Instruction Booklet

Hand vacuum cleaner
Table of Contents

Advertisement

Available languages

Available languages

S726**** 14
DO-203S
Always return the unit to the charging base immediately after use so that it will be
ready and fully charged for it's next use.
ASSEMBLY
NOTE : dust cup filter must always be used when operating the cordless hand vac.
To open the dust cup compartment, push the dust cup release button and remove the
dust cup container.
Verify that the dust cup filter is inside, then re-attach the dust cup container to the
cordeless hand vac.
To attach the crevice tool or the dusting brush to the cordless hand vac, push the
attachment into the suction hole in the front of the dust container.
USING THE CORDLESS hand VAC
Remove the cordless hand vac from the charging base
To start the unit, push the "on/off" switch to the "on" position.
A crevice tool is provided for cleaning narrow, hard to reach places. A dusting brush is
provided for cleaning upholstery, furniture, etc.
USING YOUR MOTORIZED BRUSH
Remove the power plug from the electrical outlet.
Remove the cordless hand vac from the charging base.
Make sure that it is in the "off" position.
Firmly insert the motorized brush into the air-intake nozzle of the dust cup container
ensuring that the contact pins are engaged in the connector slots of the unit.
Please note that this motorized brush is for vacuuming short pile carpets and rugs.
WARNING : do not touch the motorized brush while it is in motion.

CHANGING AND CLEANING THE DUST CUP FILTER

To achieve the best performance, empty the dust cup container and clean the dust cup
filter after each use.
To remove the dust cup container, press down on the dust cp release button and pull
off the dust cup container.
Pull out the dust cup filter.
Empty the dust from the dust cup container.
Rinse the dust cup filter in cold water, and then wait until it dries completely before
replacing it back into the dust cup container. Do not use a washing machine to clean
the dust cup filter. Do not use a hair dryer to dry it. Air dry only.
Replace the dust cup filter carefully into the dust cup compartment. Never operate
vacuum cleaner without dust cup filter in place.
Attach the dust cup container to the cordless vacuum.
NOTE : it is recommended that the dust cup filter be replaced every three months to
ensure peak performance of the unit.
CAUTION : the suction hole must be open and free of any obstructions at all times.

Advertisement

Table of Contents
loading

Table of Contents