Network Settings - Sling Media SlingPlayer Mobile User Manual

Network Settings

Follow these steps if you did not set up remote viewing when you first installed SlingPlayer or if you
would like to change your network settings.
Note
These instructions are for SlingPlayer for PC.
Note
You can enable remote viewing only from the same local
network as your Slingbox.
To change the network settings:
1. Select View > Slingbox Directory.
The Slingbox directory opens.
2. Select the Slingbox you want to change and click Edit Properties.
The Slingbox properties window opens.
3. Select the Slingbox Configuration tab.
4. In the Network Settings section, click Change.
The Slingbox Setup Wizard starts. Follow the on-screen instructions.
5. Click Next.
6. Select the check box if you want to enable remote viewing. Click Next.
7. Select the router configuration mode. Click Next.
8. If you selected Semi-Automatic or Manual:
a. Enter the IP address, subnet mask, and default gateway. Click Next.
b. Enter the Port Number. Click Next.
c. Enter the generated Slingbox information in your router's administration screens.
9. Select Ready to continue and test remote viewing. Click Next.
10. Make a note of your Finder ID. Click Next.
11. Once the wizard verifies remote viewing, click Next.
12. Click Finish.
The wizard closes and the updates the changes.
Slingbox User Guide
Network Settings
41