Table of Contents
Advertisement
Service Diagnostics and Procedures
Grill Igniter
The unit uses a spark igniter to create ignition of
the burners. When the ignition switch is depressed,
the ignition module sends power to the igniter, and
ignites the gas supplied by the burner valve.
To access the igniter:
1. Access control panel components (see Control
Panel Components Access section, page 14).
Disconnect wires and remove control panel.
2. Remove grill grates and flavor generators.
3. Locate igniter(s) and disconnect wiring.
© 2011 Viking Preferred Service
4. Remove grill burners (see Grill Burner section,
page 19).
5. Remove screw and igniter from burner.
6. Reverse procedure to reassemble.
If the igniter fails to spark, first do a resistance
check on the igniter. If the igniter shows 0 , ensure
power to the igniter from the module. If power is
supplied to the igniter and no spark, replace the
igniter.
Igniter Wire
Screw
Test Points
16
Advertisement
Table of Contents
