Page 1
Viking Installation Guide Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web site at vikingrange.com Outdoor Gas Grills F20896C EN (092812)
Table of Contents IMPORTANT – Please Read and Follow Important Safety Instructions __________________________________________________________2 WARNING WARNING Dimensions (30" & 36" 100 and 300 Series)_____________________________________________4 Specifications (30" & 36" 100 and 300 Series)___________________________________________5 Keep electrical supply cord and the fuel supply This outdoor gas grill is not intended to be Dimensions (30"...
General Information General Information • A minimum of 6” (15.2 cm) from the sides, • When determining a suitable location for • Keep grill area clear and free from combustible WARNING materials, gasoline, and other flammable or a minimum of 8” (20.3 cm) from the the grill, take into account concerns such right side if there is a rotisserie motor and as exposure to wind, proximity to traffic...
Cutout Dimensions Cutout Dimensions (100 and 300 Series 36”W. Grill) (500 Series 30”W. Grill) Gas inlet and power cord Gas inlet and power cord location area location area 8 ” - 5 / - 3 / ” - 1 / 8 ”...
Page 11
Cutout Dimensions Cutout Dimensions (500 Series 42”W. Grill) (500 Series 54”W. Grill) Gas inlet and power cord Gas inlet and power cord location area location area ” - 1 / ” ( 1 0 4 ” . 1 c 2 . 2 - 1 / Electrical connection ( 7 1...
Ventilation for Built-In Installations Gas and Electrical Connection Not more than 5.00 inches from inside Gas Connection Gas Conversion bottom of countertop. Verify the type of gas supply to be used, either To convert a grill from natural to natural or LP, and make sure the marking on the LP/Propane or LP/Propane to natural, you 5.00 inch MUST use conversion kit sold seperately.
7/8” the incoming flexible gas line, attach with a 3/8” Note: If using a Viking GSH12 flexible hose, accessible location (2.2 cm) female flare adapter to the 7/8” (2.2 cm) female flare adapter to the 3/8”...
LP/Propane Tank Requirements LP/Propane Tank Connection A dented or rusty LP/Propane tank may be Other types of caps or plugs may result in Outdoor grills orificed for use with LP/Propane connection between the regulator and the hazardous and should be checked by your tank leakage of propane.
Leak Testing Although all gas connections on the grill are leak • Do not smoke while leak testing. tested at the factory prior to shipment, a • Extinguish all flames. complete gas tightness check must be performed • Never leak test with an open flame at the installation due to possible mishandling in CAUTION shipment or excessive pressure unknowingly...
Burner Adjustment A qualified installer should perform the Flames should be blue and stable with no yellow following burner adjustments. Each burner is tips, excessive noise or lifting. If any of these tested and adjusted at the factory prior to conditions exist, check if the air shutter or burner shipment;...
Rotisserie System Performance Checklist The rotisserie motor is attached to the mounting A qualified installer should carry out the Any adjustments necessary that are the WARNING bracket located on the right side of the grill following checks: result of the installer not following frame.
Only authorized replacement parts may be used in performing service on the appliance. All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (845-4641), for the nearest service parts distributor in your area or write to:...