Table of Contents
Advertisement
Click Configuration > Security > IPv6 Firewall. The IPv6 Firewall screen appears as shown.
Figure 58 Configuration > Security > IPv6 Firewall
The following table describes the labels in this screen.
Table 41 Configuration > Security > IPv6 Firewall
LABEL
DESCRIPTION
Enable Firewall Rule
Enable Firewall Rule
Select this check box to activate the firewall rules that you define (see Add Firewall Rule
below).
Filter table type
Select DROP to silently discard the packets which meet the firewall rules. The others are
accepted.
Select ACCEPT to allow the passage of the packets which meet the firewall rules. The others
are blocked.
Add Firewall Rule
Service Name
Enter a name that identifies or describes the firewall rule.
MAC Address
Enter the MAC address of the computer for which the firewall rule applies.
Dest IP Address
Enter the IPv6 address of the computer to which traffic for the application or service is
entering.
The EMG2881-T20A applies the firewall rule to traffic destined for this computer.
Source IP Address
Enter the IPv6 address of the computer that initializes traffic for the application or service.
The EMG2881-T20A applies the firewall rule to traffic initiating from this computer.
Protocol
Select the protocol (TCP, UDP or ICMPv6) used to transport the packets for which you want
to apply the firewall rule.
Dest Port Range
Enter the port number/range of the destination that defines the traffic type, for example
TCP port 80 defines web traffic.
Source Port Range
Enter the port number/range of the source that defines the traffic type, for example TCP
port 80 defines web traffic.
Add Rule
Click Add Rule to save the firewall rule.
Firewall Rule
Chapter 10 Security
EMG2881-T20A User's Guide
96
Advertisement
Table of Contents
