Nt8D7206, Nt8D7207; Qcad128 - Nortel Succession 1000 Installation And Configuration Manual

NT8D7206, NT8D7207

QCAD128

This cable is used to transport the 2Mb/s digital signal from the PRI pack to
the I/O assembly located at the cabinet bulkhead.
• Standard length -
3.05 m (10 ft.) for Half Group systems and Single group systems
• Construction - 24 AWG, stranded foil-shielded twisted pairs
• P1 Connector (Pack end) - 9-pin, male, subminiature D, with jack-screws
• P2 Connector (I/O Panel end) - 9-pin, male, subminiature D, with
jack-screws
Table 108
NT8D7206, NT8D7207 wire list
From
Color (pack end)
White P1-1
Black P1-9
Green Shield nc
Red P1-3
Black P1-11
Red Shield nc
This cable transports the T1 signal from the PRI pack to the I/O panel.
• Standard length - 10 ft. (3.05 m)
• Construction - 15-conductor ribbon, 28 AWG (0.321 mm), stranded
• P1 Connector - 15-pin, male, subminiature D, with jack-screws
• P2 Connector - 15-pin, male, subminiature D, with jack-screws
ISDN Primary Rate Interface
Non-standard cables
To
(I/O end)
P2-6
P2-7
P2-CASE P2-9
P2-2
P2-3
P2-CASE P2-5
Installation and Configuration
Page 387 of 396
Signal
XTIP (transmit)
XRING (transmit)
GROUND
RTIP (receive)
RRING (receive)
GROUND