Port Addressing Modes - Nortel Succession 1000 Installation And Configuration Manual

Figure 37
NT6D11 DCH with ISL low-speed programming jumper settings

Port addressing modes

DCE
DTE
PORT 0
DCE
DTE
DCE
DTE
PORT 1
DCE
DTE
Port 0 Mode selection
Port 0 is used to select whether the asynchronous ESDI port is be disabled or
not. Refer to Table 24.
Note: The asynchronous ESDI port must be set to "disabled".
Table 24 (Part 1 of 2)
Port 0 mode selection
Port Mode
ISDN Primary Rate Interface
DCH installation
RS-232
RS-422
RS-232
RS-422
RS-232
RS-422
RS-232
RS-422
Switch Setting
SW1.1
Page 107 of 396
553-7351
SW1.2
Installation and Configuration