Isl Hardware Installation - Nortel Succession 1000 Installation And Configuration Manual

ISL hardware installation

Shared mode
Dedicated mode
The hardware installation is identical to the PRI installation, with the addition
of analogue or digital TIE trunks (or both).
Procedure 42
Installing the NTAK02
The NTAK02 connects to the modem through the NTAK19BA 4-port cable.
Only ports 1 and 3 are available for use as DCHIs.
1 Set option switches/jumpers on the DCHI card, as shown in Table 104
and Table 105, for mode of operation that is, RS232 or RS422 and DTE
or DCE.
2 Install the NTAK02 in any spare slot 1-9 of the Main Cabinet or slots 11-14
of the Succession Media Gateway.
3 Install the NTAK19BA four port cable on the 50-pin Amphenol connector
associated with the slot holding the NTAK02.
Table 104
NTAK02 switch settings
Port 0
SDI
SDI
—
Port 2
SDI
SDI
—
ISDN Primary Rate Interface
2.0 Mb ISL implementation
Port 1 SW1-1
DCH OFF
DPNSS1 OFF
ESDI ON
Port 3 SW1-3
DCH OFF
DPNSS1 OFF
ESDI ON
Page 375 of 396
SW1-2
OFF
ON
ON
SW1-4
OFF
ON
ON
Installation and Configuration