Install The Nt5D97 Ddp2; Use Procedure 14 To Install The Nt5D97 On Large Systems - Nortel Succession 1000 Installation And Configuration Manual

Page 172 of 396
Table 54
Switch setting for MSDL external card (Part 2 of 2)
DNUM (LD 17)
14
15

Install the NT5D97 DDP2

553-3001-201 Standard 1.00
NT5D97 Dual-port DTI2/PRI2 installation and removal
1
OFF ON
ON ON

Use Procedure 14 to install the NT5D97 on Large Systems.

CAUTION
The static discharge bracelet located inside the
cabinet must be worn before handling circuit cards.
Failure to wear the bracelet can result in damage to
the circuit cards.
Procedure 14
Install the NT5D97 on Large Systems
1 Determine the cabinet and shelf location where the NT5D97 is to be
installed. The NT5D97 can be installed in any card slot in the Network
bus.
2 Unpack and inspect the NT5D97and cables.
3 If a DDCH is installed, refer to the section "NTBK51 DDCH installation and
removal" on page
4 Set the option switches on the NT5D97 card before installation. Refer to
"NT5D97AA/AB DIP switch settings" on
The ENB/DIS (enable/disable faceplate switch) must be OFF (DIS) when
installing the NT5D97, otherwise a system initialize can occur. The
ENB/DIS on the NT5D97 corresponds to the faceplate switch on the
QPC414 Network card.
5 Install NT5D97 card in the assigned shelf and slot.
October 2003
Switch Setting
2
ON
ON
117.
3 4
ON
ON
page 160.