Table of Contents
Advertisement
Page 278 of 396
Software enable the DTI/PRI cards
553-3001-201
Standard 1.00
1.5 Mb DTI implementation
For Succession 1000, connect the NTBK04 cable to a 50-pin amphenol
connector on the rear of the Succession Media Gateway chassis. The
amphenol connectors are labelled with the card slot numbers to which they
correspond.
The NTBK04 is twenty feet long. If additional distance is required, the
NT8D97AX 50-foot extension is available up to a 600-foot maximum. The
only cable required to support the NTAK09 circuit card is the NTBK04.
Pinout information on the NTBK04 cable is given in Table 79.
Table 79
DS-1 line interface pinout for NTBK04 cable
From 50-pin
MDF connector
pin 48
pin 23
pin 25
pin 49
pin 24
Procedure 34
Enabling the NTRB21 TMDI card
1
Enter the following command in LD 96 to enable the NTRB21 TMDI card:
ENL TMDI x ALL
where x is the NTRB21 TMDI card number (DLOP). The card number
associated with a NTRB21 TMDI card is based on the slot in which the
card is installed.
October 2003
to DB-15
Signal
name
pin 1
T
pin 9
R
pin 2
FGND
pin 3
T1
pin 11
R1
Description
transmit tip to network
transmit ring to
network
frame ground
receive tip from
network
receive ring from
network
Advertisement
Chapters
Table of Contents
