Advertisement
PROGRAMMING GUIDE
Programming Options (cont.)
1, 2
Dispense Total
- when accessed, displays the total dispense cycles on the unit. It cannot be reset. The
display returns to the previous screen automatically after a few seconds. Press
menu.
1, 2
Language
-
to access. Press
or
menu.
1
Valve Calibrate
-
calibrated. See Dump Valve Calibration in the Troubleshooting Section for the complete dump valve calibration
procedure. Press
to access. The bottom portion of the display will read "Select Station". Place an empty
measuring cup under the dispensing spout for the valve to be calibrated. Press the PUSH button above the
continue to the next menu.
1, 2
Model Select
- changes the model number. The unit must be set to the proper model number for proper
operation. Press
to access. Press
unit appears, then press
1 Not present on Pre-Set Dispense models
2 Not present on PCGT6 series models
to choose the desired setting, then press
or
until the model number matching the model number label on the
to exit. Press
to continue to the next menu.
to continue to the next
to exit. Press
to continue to the next
PG12
to
Advertisement
