Advertisement
INSTALLATION INSTRUCTIONS
Power Up the Unit
24 Turn on the water supply valve.
25 Make sure that the circuit breaker supplying power to
the dispenser is on.
26 Turn the toggle switch on the back of the dispenser to
27
correct volume, the heating element(s) will turn on
automatically. Depending on the incoming water
tank typically requires 1 hour to reach the factory set
"Ready to Dispense" should be on the display.
28 If the unit is equipped with a hot water faucet, before
water from the hot water faucet to help purge air from
the tubing inside the unit.
29 Dispense at least 12 oz./350 ml from each spout,
to purge any remaining air from the tubing. See
OPERATING INSTRUCTIONS. During initial
tubing and water tank.
II22
090919C
Advertisement
