Advertisement
PROGRAMMING GUIDE
Programming Options
PROGRAMMING GUIDE for instructions on how to access the programming menu.
To exit programming mode, press
Manual Dispense - All stations are set to Manual Dispense mode at the factory (except on Pre-Set Dispense
to be set to Manual Dispense. "Saving Complete!" will appear on the display, then return to the programming
menu. Repeat the process to set other stations, if desired, or press
Dispense by Time - (default on Pre-Set Dispense Models) sets the unit
to dispense the amount of product by time rather than holding the button
until the desired amount is dispensed. Place a cup below the spout for
the desired station. Press
desired PUSH button. Hot water will start to dispense and the screen
will display "To Finish Push PUSH". When the desired volume is reached
stations if desired, or press
Temperature -
to set and exit. Press
Powder % Ratio - sets the ratio of product powder dispensed. The
higher the powder ratio, the richer the product dispensed. The factory
desired station. Press
press
to set and exit. Press
Service Call - sets the service phone number that appears on the
display when the unit detects a SENSOR ERROR or WATER LEVEL
ERROR. Press
to access. Press
changed. Then press
or
to choose the next number to change or choose ex and press
to exit. Repeat the process to set other stations, or press
next menu.
Banner Name - changes the banner name that appears on the display (the factory default is CURTIS
change. Then press
choose ex and press
1, 2
Dispense Odom
- displays the total dispense cycles since the odometer was last reset. Press
Press
to exit or
reset and exit. Press
1 Not present on Pre-Set Dispense models
2 Not present on PCGT6 series models
until EXIT appears on the display, then press
to access. Press the PUSH button for the
to go to the next menu.
to access. Press
to continue to the next menu.
to access. Press the PUSH button for the
or
to increase or decrease the ratio, then
to continue to the next menu.
or
to choose the number to be
repeatedly to change the number value. Press
repeatedly to change the letter. Press
to exit. Press
to continue to the next menu.
to continue to the next menu.
to access, then press the PUSH button for the station
to go to the next menu.
Default Settings Time Dispense Settings
or
to choose the desired temperature. Then press
% Ratio
to go to the
to access. Press
or
to choose the next number to change or
PG12
.
Preset Dispense Models
Cup Size
Time Setting
LARGE
25.5 Seconds
MEDIUM
16.5 Seconds
SMALL
12.5 Seconds
Grams*
10%
7 gm
20%
14 gm
30%
21 gm
40%
28 gm
50%
35 gm
60%
42 gm
70%
49 gm
80%
56 gm
90%
63 gm
100%
70 gm
*Approximate
or
to choose the letter to
to access.
Advertisement
