Installation Guidelines - Elation PIXEL DRIVER 4000 V3 User Manual

Table of Contents

Advertisement

INSTALLATION GUIDELINES

FLAMMABLE MATERIAL WARNING!
Keep drive a minimum of 5.0 feet (1.5m) away from flammable material and/or
pyrotechnics.
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or devices.
FOR USE IN INDOOR OR DRY LOCATIONS ONLY!
DO NOT EXPOSE TO RAIN OR MOISTURE!
DO NOT INSTALL THE DEVICE IF YOU ARE NOT QUALIFIED TO DO SO!
Device MUST be installed following all local, national, and country commercial electrical and
construction codes and regulations.
Before rigging/mounting the device to any metal truss/structure or placing the device on any
surface, a professional equipment installer MUST be consulted to determine if the metal truss/
structure or surface is properly certified to safely hold the combined weight of the device,
clamps, cables, and accessories. Overhead device installation must always be secured with a
secondary safety attachment, such as an appropriately rated safety cable that meets all local,
national, and country codes and regulations.
Device ambient operating temperature range is 14° to 113°F (-10° to 45°C). Do not use the
device when the ambient temperature falls outside of this range.
Device should be installed in areas outside walking paths, seating areas, or away from areas
were unauthorized personnel might reach the fixture by hand.
NEVER stand directly below the device when rigging, removing, or servicing.
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pix698

Table of Contents