Epson ES-C380W User Manual page 241

Administrator Information
1. Select Settings on the scanner's control panel.
2. Select System Administration > Admin Settings.
3. Select Admin Password > Change.
4. Enter your current password.
Note:
The initial administrator password (default) at the time of purchase varies depending on the label attached to the
product. If there is a "PASSWORD" label attached to the back, enter the 8-digit number shown on the label. If there is
no "PASSWORD" label attached, enter the serial number on the label attached to the base of the product for the initial
administrator password.
5. Enter your new password.
The new password must be 8 to 20 characters long and only contain single-byte alphanumeric characters and
symbols.
Important:
c
Be sure to remember the administrator password you set. If you forget your password, you will not be able to
reset it and you will need to request help from service personnel.
6. Enter the new password again for confirmation.
A completion message is displayed.
Changing the Administrator Password Using Web Config
Change the administrator password in Web Config.
1. Access Web Config and select the Product Security tab > Change Administrator Password.
2. Enter the necessary information in Current password, User Name, New Password, and Confirm New
Password.
The new password must be 8 to 20 characters long and only contain single-byte alphanumeric characters and
symbols.
Note:
The following provides the default values for the administrator information.
❏ User name: none (blank)
❏ Password: Depends on the label attached to product.
If there is a "PASSWORD" label attached to the back, enter the 8-digit number shown on the label. If there is no
"PASSWORD" label attached, enter the serial number on the label attached to the base of the product for the initial
administrator password.
Important:
c
Be sure to remember the administrator password you set. If you forget your password, you will not be able to
reset it and you will need to request help from service personnel.
3. Select OK.
> >
Administrator Settings
241
Configuring the Administrator Password