1 Safety instructions • Read this document before setting up the product and keep it during the entire service life. • The product must be suitable for the corresponding applications and environmental conditions without any restrictions. • Only use the product for its intended purpose (→ 2 Functions and features). •...
For units with metal housing (according to UL 508): ► Observe a minimum distance of 12.7 mm between the sensor and non- insulated live parts. For further information please refer to www.ifm.com → General information about installation and operation. 4 Electrical connection ►...
Page 4
5.2 Teach button 5.2.1 Start programming mode ► Press the teach button for 2 s...6 s. > Yellow status LEDs flash (1 Hz), the unit is in the programming mode. If programming has not been completed successfully, the unit returns to the previous setting.
Page 5
Switching signal for window function Switching signal for hysteresis function P1/P2 1: output response B: blind zone 2: inverted output signal P: taught position 3: distance object T: teach button 4: factory setting Technical data and further information at www.ifm.com...