Making Coffee Using Ground Coffee; Making Cappuccinos And Milk-Based Coffees; Filling And Attaching The Milk Container - DeLonghi PrimaDonna Elite ECAM65 55 Series Instructions For Use Manual

Hide thumbs Also See for PrimaDonna Elite ECAM65 55 Series:
Table of Contents

Advertisement

You can prepare 2 cups of ESPRESSO coffee at the same
y and
time by pressing "2X
a few seconds whenever you start preparing 1 ESPRESSO)
at the
or selecting "2X ESPRESSO" from the beverage selection
ery is
menu (B3);
usting
While the machine is making coffee, delivery can be in-
terrupted at any moment by pressing the selection arrow
corresponding to "STOP ".
As soon as delivery has ended, to increase the quantity of
n the
coffee in the cup, just press the selection arrow correspond-
ing to "EXTRA
or not
press the selection arrow corresponding to "STOP
rds 7.
Once the coffee has been made, the appliance is ready to make
turn
the next beverage.
1 (do
time
Please note!
vered
Various alarm messages could be displayed while using
the appliance (FILL TANK, EMPTY GROUNDS CONTAINER,
ups of
etc.). Their meaning is explained in section "21. Displayed
messages".
n the
For hotter coffee, see section "9.4 Tips for a hotter coffee".
If the coffee is delivered a drop at a time, too weak and not
creamy enough or too cold, read the tips in section "9.3 Ad-
justing the coffee mill" and section "22. Troubleshooting".
Preparation of each coffee can be customised (see sections
ion in
"13. Customising the beverages" and "14. Memorising your
personal profile").
nction

9.6 Making coffee using ground coffee

u (see
Important!
Never add ground coffee when the machine is off or it
could spread through the inside of the machine and dirty
it. This could damage the appliance.
Never use more than 1 level measure (C2) or it could dirty
the inside of the coffee machine or block the funnel (A4).
could
Please note!
If you use ground coffee, you can only make one cup of coffee
at a time.
. 12).
1. Press the selection arrow (B2) corresponding to "AROMA"
(B5) until "
2. Open the ground coffee funnel lid (A2).
3. Make sure the funnel (A4) is not blocked, then add one
level measure of ground coffee (fig. 13).
4. Posizionare una tazza sotto i beccucci dell' e rogatore caffè
(A8) (fig. 12).
erage
5. Place a cup under the coffee spouts (A8) (fig. 12).
ss bar
- ESPRESSO (B14)
- COFFEE (B15)
- LONG (B16)
" (the image is displayed for
". When the required quantity is reached,
" (ground) appears on the display (B1).
6. Preparation begins. An image of the selected beverage
appears on the display, together with a progress bar which
gradually fills as preparation progresses.
Important! Making LONG coffee:
Halfway through preparation, the message "ADD Ground COF-
FEE" is displayed. Add one level measure of ground coffee and
press "OK " .
Please note!
If "Energy Saving" mode is active, you may have to wait a few
seconds before the first coffee is delivered
".
10. MAKING CAPPUCCINOS AND MILK-BASED
COFFEES
Please note!
To avoid milk with poor froth or large bubbles, always clean
the milk container lid (D2) and hot water connection noz-
zle (A9) as described in sections "10.4 Cleaning the milk
container after use", "15.10 Cleaning the milk container"
and "15.11 Cleaning the hot water/steam connection
nozzle".

10.1 Filling and attaching the milk container

1. Remove the lid (D2) (fig. 14);
2. Fill the milk container (D3) with a sufficient quantity of
milk, not exceeding the MAX level marked on the contain-
er (fig. 15). Each mark on the side of the container corre-
sponds to about 100 ml of milk;
Please note!
For a denser more even froth, you must use skimmed or
partially skimmed milk at refrigerator temperature (about
5°C).
If "Energy Saving" mode is enabled, you may have to wait a
few seconds before the beverage is delivered.
3. Make sure the milk intake tube (D4) is correctly inserted in
the bottom of the milk container lid (fig. 16);
4. Place the lid back on the milk container;
5. If present, extract the hot water/steam spout (C6) by press-
ing the release button (C7) (fig. 17);
6. Attach the milk container (D) to the connection nozzle (A9)
(fig. 18) and push as far as it will go. The machine emits a
beep (if the beep function is enabled);
7. Place a sufficiently large cup under the coffee spouts (A8)
and frothed milk spout (D5). Adjust the length of the milk
spout. To move it nearer the cup, simply pull it downwards
(fig. 19).
8. Follow the instructions below for each function.
15

Advertisement

Table of Contents
loading

Table of Contents