Table of Contents
Advertisement
10 Auto Calibration & Firmware Update
Auto Calibration
Auto calibration could reduce drift or slight deviation caused by nearby magnetic
interference or human error.
Calibration failure might happen if the gimbal is not placed on a
flat surface for calibration (e.g. calibration in a running vehicle).
1. Place gimbal on a flat surface by
means of a tripod.
3. Press the M button five times to
enable the auto calibration and
you will hear a beep sound. Please
do not touch the gimbal during
calibration.
*If the calibration fails, the stabilizer will enter standby mode after two beeps. Press
any button (except the joystick) to wake up the stabilizer. Then, repeat the calibration
process following the steps mentioned above.
Firmware Update
You will be prompted in the Hohem Joy App if a new firmware update is available.
Follow the on-screen instructions in the App to update firmware.
2. Double press the trigger to
recenter the gimbal.
4. The second beep indicates that
the calibration is completed, and
the gimbal will be recentered
automatically.
22
Hide quick links:
Advertisement
Table of Contents
