Advertisement
EDGE BEAM
Absco Industries
Assembly Instruction Manual
ABSCO GABLE CARPORT
MODEL: GCPSN2
3.0mW x 6.0mD x 2.66mH
- That completes the side beam assembly -
1. Arrange the six edge beam
pieces as shown on the left.
Inner
2. Nest the Inner edge beams
inside the outers.
Check for straightness.
When happy with the fit and the
assembled length is 5920 mm
proceed to fastening.
Fasten all with tek screws at 300
centres.
TIP: The top side of the beam
needs wafer head teks. The
underside of the beam can be
hex head tek screws
3. Remove all screws for the
two outer edge beam pieces
ZACO117.
This will allow access to fit the
columns later.
Repeat these steps again we
need two edge beams.
Model: GCPSN2
Outer
8/6/23
9
Advertisement
