Advertisement
POSTS
Absco Industries
Assembly Instruction Manual
ABSCO GABLE CARPORT
MODEL: GCPSN2
3.0mW x 6.0mD x 2.66mH
BKT03
BKT17
- That completes the post assembly -
1. Take a COL04 and a BKT03.
Align the bottom edge of the
bracket with the end of the post.
Using the two holes in the
bracket as a template mark and
drill out with a 10mm drill bit.
TIP: Predrilling can make this
step easier.
2. Repeat to all four faces of the
column.
3. Place a BKT03 and fasten with
a pair of M10 x 20mm bolts, nuts
and washers.
Poke the bolt through from the
inside of the post and use a nut
and washer on the outside.
Turn over and repeat for the
opposite side.
4. Fasten the remain two BKT03
brackets using a pair of M10 x
100mm bolts, nuts and washers.
These are simple through-bolts.
5. Take a BKT17, align the edge
with the top end of the post
and fasten with six hex head tek
screws.
Repeat these steps until you
have four columns.
Model: GCPSN2
8/6/23
10
Advertisement
