Connecting Devices
Connect a commercially available controller or computer and a projector to AN-LS1.
Connecting a Controller or a Computer
In the case of controlling a projector via RS-232C as well as via the Ethernet LAN, connect a
commercially available controller or computer to the RS-232C (CONTROLLER) terminal.
For connection procedures for each device, please refer to the operation manual for each device.
Make sure not to connect a controller or a computer to the RS-232C (PROJECTOR) terminal.
Set as follows for the Port settings for RS-232C.
Baud Rate
Data Length : 8 bits
Parity Bit
Stop Bit
Flow Control : None
In the case of connecting to a controller, use a suitable cable for the RS-232C cable.
In the case of connecting to a computer, use a cross-over type cable for the RS-232C cable.
Connecting a Projector
Connect a projector to the RS-232C (PROJECTOR) terminal.
For connection procedures for a projector, please refer to the operation manual for the projector.
In the case of connecting to a projector, use a cross-over type cable for the RS-232C cable.
RS-232C (CONTROLLER)
To RS-232C terminal
RS-232C serial control
cable
(commercially available)
: Set the same value as AN-LS1.
: None
: 1 bit
RS-232C (PROJECTOR)
To RS-232C terminal
RS-232C serial control
cable
(commercially available)
9
Controller
(commercially available)
or
Computer
(Page
11)
Projector