When Connecting Using Telnet - Sharp AN-LS1 Operation Manual

When Connecting Using Telnet

1
Click "Start" from the Windows desktop and select "Run".
2
Enter "telnet 192.168.150.2" in the text box that opens up.
(If the IP address of the unit is 192.168.150.2.)
3
Click "OK".
4
"User Name:" is displayed. Input the user name and press the return key.
(If a user name has not yet been set, just press the return key.)
5
"Password:" is displayed. Input the password and press the return key.
(If a password has not yet been set, just press the return key.)
6
Input "setup" and press the return key.
| SETUP MENU will be displayed.
[1]IP Address
[4]User Name
[6]RS-232C Baud Rate [7]Unit Name
[A]Advanced Setup
[V]View All Setting
setup>
If the IP address has been changed, be sure to enter the correct IP address.
User name and password are not set in the initial settings.
If the user name or password is entered incorrectly three times, SETUP MENU will be quit.
S E T U P M E N U
[2]Subnet Mask [3]Default Gateway
[5]Password
[D]Disconnect All
[S]Save & Quit [Q]Quit Unchanged
12