Sharp AN-LS1 Operation Manual page 23

Carrying out Network Ping Test (ADVANCED[5]Network Ping Test)
It is possible to confirm that a network connection between AN-LS1 and a computer etc. is working
normally.
advanced>5
Ping dest IP addr :192.168.150.1
Please Enter
(change)
32 bytes from 192.168.150.152: icmp_seq = 1, time = 0 ms
32 bytes from 192.168.150.152: icmp_seq = 2, time = 0 ms
32 bytes from 192.168.150.152: icmp_seq = 3, time = 0 ms
32 bytes from 192.168.150.152: icmp_seq = 4, time = 0 ms
If the return key is pressed without entering an IP address, the Ping destination IP address used
before is entered.
If there is a fault with the connection, "Error: No answer" is displayed after a 5 second retry. In
this case, please confirm the settings for AN-LS1 and the computer, and contact your network
administrator.
Setting of Accept IP Address (ADVANCED[6]Accept IP Addr(1) - [8]Accept IP Addr(3))
It is possible to improve security of AN-LS1 by allowing connection from only a prescribed IP address.
It is possible to set up to three IP addresses allowing connection to AN-LS1.
advanced>6
Accept IP Addr(1) : 0.0.0.0
Please Enter
(change)
To invalidate the Accept IP Address being currently set, enter "0.0.0.0".
If there is one or more Accept IP Addr being set, no connections are allowed from IP addresses
that are not yet set. They can be cancelled using [9]Accept All IP Addr.
Accepting All IP Addresses (ADVANCED[9]Accept All IP Addr)
Removes IP addresses set with "Accept IP Addr".
advanced>9
Accept All IP Addresses(y/n)? y
At the point in time where "y" was entered, the numerical values for Accept IP Addr(1)-(3) are
reset to "0.0.0.0".
If "n" is entered, settings are not altered.
:192.168.150.152
—> 192.168.150.152
: 192.168.150.152
—> 192.168.150.152
23
Enter "5" and press the return key.
Enter IP address of device to be
tested and press the return key.
Display entered IP address.
Display test result.
Enter "6", "7" or "8" and press
the return key.
Enter numerical value and press
the return key.
Display set numerical value.
Enter "9" and press the return key.
Enter "y" and press the return key.